2016 Mitsubishi Fuso Truck Manual
When gear is shifted while the air pressure is low, “TM AIR PRESS TOO LOW” or “T/M SYSTEM FAILURE” indications may appear or the gearshift may not operate properly. In addition, if the vehicle is driven when the air pressure is low, equipment other than T/M applying air pressure including brakes may not operate properly and would be very dangerous. Below are representative examples related to low air pressure. Please make use of these examples and check the air pressure gauge in the instrument panel and measure the time of air pressure build-up at all times in your daily operation for your safety and comfort. This kind of information (indications and warning, etc.) are available in your Owners handbook. Important Remarks Please also be reminded that the owner of the truck is fully responsible for proper inspection and maintenance. Owner’s Handbook and/or Service Booklet is the guidebook for this purpose.
Up to 35% Off Mitsubishi FUSO Heavy Truck Diagnostic Scan Tools and Diesel. 1986 - 2016 FUSO CANTER FE, FG, FH, FK, FM Truck Service Manual DVD. Mitsubishi Canter Service and Repair Manuals. Every Manual. The Mitsubishi Fuso Canter is a line of light-duty commercial vehicle built by Mitsubishi Fuso Truck.
When inspection and maintenance are performed, results must be recorded in the Owner’s Handbook and/or Service Booklet which is to be used as a lifetime logbook of the vehicle. MFTBC reserves the right to void any warranty if the periodical inspection designated by MFTBC is not carried out according to the MFTBC guideline. This indications show that the air pressure used to control the transmission has decreased. Snap-on tools owners. If the indication goes off after taking the steps described below, you can drive the vehicle, however, please check the air pressure gauge for sufficient brake air pressure (refer to Table 1) before driving.
If indications appear while vehicle is moving Press the brake pedal and immediately stop the vehicle in a safe place. If the indications do not go off after a while, contact an authorized MITSUBISHI FUSO distributor or dealer. If you wish to stop the engine, first, to place the gearshift lever in the “N” position and check that the gear position indicator shows “N”. If indications appear when engine is started If the indications appear when the engine is started, do not drive the vehicle until they have gone off.
If you wait a while but the indications do not go off, contact an authorized MITSUBISHI FUSO distributor or dealer. If you can't start the engine To place the gearshift lever in the “N” position. When the gear position indicator shows “N”, start the engine. If the gear position indicator does not show “N”, contact an authorized MITSUBISHI FUSO distributor or dealer. If indications appear while vehicle is moving Immediately press the brake pedal and stop the vehicle in a safe place. Action after stopping Place the gearshift lever in the “N” position, then stop the engine.
Restart the engine after waiting about 10 seconds. Restarting the engine may reset the computer program and the system may start working normally in some cases, but this may not take place in other cases.
2016 Mitsubishi Fuso Truck Manual Pdf
If you can't start the engine, warning remains displayed or if it appears repeatedly, contact an authorized MITSUBISHI FUSO distributor or dealer.